ABS Filament - PrusaSlicer
Introduction
This is a comprehensive materials settings guide to help get started!
The settings listed below have been found to produce the best results in our test lab. However, every printer is unique and different, and settings need to be tweaked based on the hardware. Consider these parameters as a solid starting point rather than rigid, foolproof configurations. You can always reach out to us at support@numakers.com if you have any questions.
Drying recommendation
|
Temp (°C) |
80 |
|
Time (h) |
4-6 |
Instructions
Advanced settings enabled
Settings
Filament settings
|
Extrusion multiplier |
1 |
|
Extruder First layer (+/- 5 °C based on hardware) |
250 |
|
Extruder Other layers |
250 |
|
Bed First layer |
100 |
|
Bed Other layers |
110 |
Cooling
|
Keep fan always on |
No |
|
Enable Autocooling |
Yes |
|
Fan speed, min |
15 |
|
Fan speed, max |
15 |
|
Bridges fan speed |
25 |
|
Filament type |
ABS |
|
Max volumetric speed |
11 |
Filament Overrides
|
Retraction length (direct drive) |
N/A |
|
Retraction length (bowden) |
5 |
|
Lift Z |
N/A |
Recommended printer upgrades
|
Special Nozzle |
None |
|
Bed adhesion |
PEI, Glass Plate, Painter's tape, Glue stick |
|
Heated bed |
Required |
|
Enclosure |
Required |